Citation: | ZHAO Q, GONG J B, ZHANG K, et al. Research on design point performance of turbine based continuous detonation combined engine[J]. Journal of Experiments in Fluid Mechanics, doi: 10.11729/syltlx20230049. |
A parallel configuration of a separate exhaust turbine based continuous detonation combined engine is proposed, in which a high temperature and high pressure air mass is induced from the exit of the turbine-based high pressure compressor to supply the detonation combustor for pressurized combustion to increase the overall engine thrust. The overall performance analysis model was established for the combined engine, and the optimization of the cycle parameters at two different design points (H = 0 and Ma = 0 at the takeoff point in standard atmospheric conditions at sea level, H = 11 km and Ma = 1.4 at the usual flight point at high altitude) was focused on according to the established model. The results show that the combined engine thrust increases with the increase of the detonation combustor exit temperature, while the fuel economy decreases significantly, each 100 K increase in the detonation combustor exit temperature, the thrust increase of about 1.96% under the ground design point, specific fuel consumption increased by about 2.9%, the thrust increase of about 2.56% under the high altitude design point, specific fuel consumption increased by about 2.26%; The larger the pressurization ratio of the detonation combustor pressurized combustion, the better the thrust performance and fuel economy of the combined engine, for every 0.1 times increase in the detonation combustor pressurization ratio, the increase in thrust at ground design point is about 1.03% and the decrease in specific fuel consumption is about 1.02%, and the increase in thrust at high altitude design point is about 0.8% and the decrease in specific fuel consumption is about 0.81%; The increase in the ratio of the gas induced from the turbine base to the detonation combustor (defined as the split fraction in the text) can improve the engine thrust performance, but the specific fuel consumption will also increase, the existence of the engine thrust performance to achieve optimal design split fraction, the optimal design split fraction of 0.3 at ground design point, the optimal design split fraction of 0.5 at high altitude design point.
[1] |
王健平, 周蕊, 武丹. 连续旋转爆轰发动机的研究进展[J]. 实验流体力学, 2015, 29(4): 12–25. DOI: 10.11729/syltlx20150048
WANG J P, ZHOU R, WU D. Progress of continuously rotating detonation engine research[J]. Journal of Experiments in Fluid Mechanics, 2015, 29(4): 12–25. doi: 10.11729/syltlx20150048
|
[2] |
范玮, 鲁唯, 王可. 脉冲爆震火箭发动机应用基础问题研究进展[J]. 实验流体力学, 2019, 33(1): 1–13. DOI: 10.11729/syltlx20180105
FAN W, LU W, WANG K. Progress in the basic application issues of the pulse detonation rocket engine[J]. Journal of Experiments in Fluid Mechanics, 2019, 33(1): 1–13. doi: 10.11729/syltlx20180105
|
[3] |
Abel F A. XIV. Contributions to the history of explosive agents[J]. Philosophical transactions of the Royal Society of London, 1869 (159): 489-516. [3] ABEL F A. XIV. Contributions to the history of explosive agents[J]. Philosophical Transactions of the Royal Society of London, 1869, 159: 489-516. doi: 10.1098/rstl.1869.0017
|
[4] |
REDDY D R. Seventy years of aeropropulsion research at NASA Glenn research center[J]. Journal of Aerospace Engineering, 2013, 26(2): 202–217. doi: 10.1061/(asce)as.1943-5525.0000312
|
[5] |
马虎, 谢宗齐, 邓利, 等. 旋转爆震发动机轴向脉冲爆震模态的实验研究[J]. 实验流体力学, 2019, 33(4): 33–38,64. DOI: 10.11729/syltlx20190015
MA H, XIE Z Q, DENG L, et al. Experimental study on the longitudinal pulse detonation in rotating detonation engine[J]. Journal of Experiments in Fluid Mechanics, 2019, 33(4): 33–38,64. doi: 10.11729/syltlx20190015
|
[6] |
Nejaamtheen M N, Kim J M, Choi J Y. Review on the research progresses in rotating detonation engine[M]//Detonation Control for Propulsion. Springer, Cham, 2018: 109-159. [6] NEJAAMTHEEN M N, KIM J M, CHOI J Y. Review on the research progresses in rotating detonation engine[M]//LI J M, TEO C, KHOO B, et al. Detonation Control for Propulsion. Cham: Springer, 2018: 109-159. doi:10. 1007/978-3-319-68906-7_6
|
[7] |
TAHSINI A M. Combustion efficiency and pressure loss balance for the supersonic combustor[J]. Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 2020, 234(6): 1149–1156. doi: 10.1177/0954410019895885
|
[8] |
FROLOV S M, AKSENOV V S, IVANOV V S, et al. Large-scale hydrogen–air continuous detonation combustor[J]. International Journal of Hydrogen Energy, 2015, 40(3): 1616–1623. doi: 10.1016/j.ijhydene.2014.11.112
|
[9] |
FALEMPIN F, LE NAOUR B. R&T effort on pulsed and continuous detonation wave engines[C]//Proc of the Proceedings of the 16th AIAA/DLR/DGLR International Space Planes and Hypersonic Systems and Technologies Conference. 2009. doi: 10.2514/6.2009-7284
|
[10] |
RUSSO R, KING P, SCHAUER F, et al. Characterization of pressure rise across a continuous detonation engine[C]//Proc of the Proceedings of the 47th AIAA/ASME/SAE/ASEE Joint Propulsion Conference & Exhibit, San Diego, California. Reston, Virigina: AIAA, 2011: AIAA2011-6046. doi: 10.2514/6.2011-6046
|
[11] |
TSUBOI N, WATANABE Y, KOJIMA T, et al. Numerical estimation of the thrust performance on a rotating detonation engine for a hydrogen–oxygen mixture[J]. Proceedings of the Combustion Institute, 2015, 35(2): 2005–2013. doi: 10.1016/j.proci.2014.09.010
|
[12] |
WANG B, WEN H, XIE Q. Recent research progress on rotating detonation and its application in different engines[C]// Proceedings of the 27th ICDERS. 2019.
|
[13] |
XIE Q F, JI Z F, WEN H C, et al. Review on the rotating detonation engine and it’s typical problems[J]. Transactions on Aerospace Research, 2020, 2020(4): 107–163. doi: 10.2478/tar-2020-0024
|
[14] |
ZHOU S B, MA H, LI S, et al. Effects of a turbine guide vane on hydrogen-air rotating detonation wave propagation characteristics[J]. International Journal of Hydrogen Energy, 2017, 42(31): 20297–20305. doi: 10.1016/j.ijhydene.2017.06.115
|
[15] |
马虎, 张义宁, 杨成龙, 等. 燃料分布对旋转爆震波传播特性影响[J]. 航空动力学报, 2019, 34(3): 513–520.
MA H, ZHANG Y N, YANG C L, et al. Effects of fuel distribution on propagation of rotating detonation wave[J]. Journal of Aerospace Power, 2019, 34(3): 513–520.
|
[16] |
NAPLES A, HOKE J, BATTELLE R T, et al. RDE implementation into an open-loop T63 gas turbine engine[C]//Proceedings of the 55th AIAA Aerospace Sciences Meeting. 2017. doi: 10.2514/6.2017-1747
|
[17] |
SOUSA J, PANIAGUA G, COLLADO MORATA E. Thermodynamic analysis of a gas turbine engine with a rotating detonation combustor[J]. Applied Energy, 2017, 195: 247–256. doi: 10.1016/j.apenergy.2017.03.045
|
[18] |
HUFF R T, BOLLER S A, POLANKA M D, et al. Radial rotating detonation engine driven bleed air turbine[J]. Journal of Propulsion and Power, 2021, 37(2): 252–260. doi: 10.2514/1.b37849
|
[19] |
RANKIN B A, FOTIA M L, NAPLES A G, et al. Overview of performance, application, and analysis of rotating detonation engine technologies[J]. Journal of Propulsion and Power, 2017, 33(1): 131–143. doi: 10.2514/1.b36303
|
[20] |
FOTIA M L, SCHAUER F, KAEMMING T, et al. Experimental study of the performance of a rotating detonation engine with nozzle[J]. Journal of Propulsion and Power, 2016, 32(3): 674–681. doi: 10.2514/1.b35913
|
[21] |
JI Z F, ZHANG H Q, WANG B. Performance analysis of dual-duct rotating detonation aero-turbine engine[J]. Aerospace Science and Technology, 2019, 92: 806–819. doi: 10.1016/j.ast.2019.07.011
|
[22] |
JI Z F, DUAN R Z, ZHANG R S, et al. Comprehensive performance analysis for the rotating detonation-based turboshaft engine[J]. International Journal of Aerospace Engineering, 2020, 2020: 9587813. doi: 10.1155/2020/9587813
|
[23] |
IVANOV V S, FROLOV S M, SERGEEV S S, et al. Pressure measurements in detonation engines[J]. Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 2021, 235(14): 2113–2134. doi: 10.1177/0954410021993078
|
[24] |
何建男, 范玮. 微尺度爆震燃烧研究进展[J]. 实验流体力学, 2016, 30(1): 15–27. DOI: 10.11729/syltlx20150135
HE J N, FAN W. Progress in the microscale detonation research[J]. Journal of Experiments in Fluid Mechanics, 2016, 30(1): 15–27. doi: 10.11729/syltlx20150135
|
[25] |
孙志鹏, 黄玥, 栾振业, 等. 高温高压进口下甲烷/氧气旋转爆震燃烧室增压特性与流场分析[J]. 推进技术, 2022, 43(11): 276–285. doi:10.13675/j.cnki. tjjs. 210751.
SUN Z P, HUANG Y, LUAN Z Y, et al. Pressurization characteristics and flow field analysis of methane/oxygen rotating detonation combustor at high temperature and high pressure inlets[J]. Journal of Propulsion Technology, 2022, 43(11): 276–285. doi: 10.13675/j.cnki.tjjs.210751
|
[26] |
QI L, ZHAO N B, WANG Z T, et al. Pressure gain characteristic of continuously rotating detonation combustion and its influence on gas turbine cycle performance[J]. IEEE Access, 2018, 6: 70236–70247. doi: 10.1109/access.2018.2880994
|
[27] |
KAEMMING T A, PAXSON D E. Determining the pressure gain of pressure gain combustion[C]//Proc of the Proceedings of the 2018 Joint Propulsion Conference. 2018. doi: 10.2514/6.2018-4567
|
[28] |
CHEN M, TANG H L, ZHANG K, et al. Turbine-based combined cycle propulsion system integration concept design[J]. Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 2013, 227(7): 1068–1089. doi: 10.1177/0954410012449246
|
[29] |
SU L J, WEN F B, WANG S T, et al. Analysis of energy saving and thrust characteristics of rotating detonation turbine engine[J]. Aerospace Science and Technology, 2022, 124: 107555. doi: 10.1016/j.ast.2022.107555
|
[30] |
YANG X K, WU Y, ZHONG Y P, et al. Investigation of rotating detonation fueled by pre-combustion cracked kerosene under different channel widths[J]. Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 2021, 235(9): 1023–1035. doi: 10.1177/0954410020965773
|