Volume 32 Issue 2
Turn off MathJax
Article Contents
Abstract
References
Related Articles
Wang Zixu, Shen Hao, Guo Long, Guo Xiangdong, Ni Zhangsong. Cloud calibration method of 3m×2m icing wind tunnel[J]. Journal of Experiments in Fluid Mechanics, 2018, 32(2): 61-67. DOI: 10.11729/syltlx20170163
Citation: Wang Zixu, Shen Hao, Guo Long, Guo Xiangdong, Ni Zhangsong. Cloud calibration method of 3m×2m icing wind tunnel[J]. Journal of Experiments in Fluid Mechanics, 2018, 32(2): 61-67. DOI: 10.11729/syltlx20170163
shu

Cloud calibration method of 3m×2m icing wind tunnel

  • 1.

    State Key Laboratory of Aerodynamics, China Aerodynamics Research and Development Center, Mianyang Sichuan 621000, China

  • 2.

    Shanghai Aircraft Airworthiness Certification Center of Civil Aviation Administration of China, Shanghai 200232, China

More Information
  • Received Date: December 12, 2017
  • Revised Date: March 21, 2018
    Graphical Abstract
    • Abstract
  • The cloud calibration has been carried out under SAE ARP5905 standard for 3m×2m icing wind tunnel, results of which can be used for certificating icing wind tunnel performance and supplying data proof for obtaining icing flight certification. Based on the ice accretion mechanism, the phase doppler interference principle, and the hot-wire principle, the calibration work was completed in the main test section by using the icing grid, PDI-FPDR, the icing blade, and LWC-200. Methods and procedures are summarized to increase the efficiency of calibration. Typical cloud calibration results indicate that the icing cloud uniformity is good, 60% of the main test section could remain target LWC within ±20%. The MVD maximum deviation is smaller than ±10%. The LWC stability is greater than ±20%. All the cloud parameters could meet the requirements of ARP5905, which could be used for supplying data proof of 3m×2m icing wind tunnel certification.
    • FullText(HTML)
    • References (14)
  • [1]
    SAE Aerospace. SAE ARP5905 Calibration and acceptance of icing wind tunnels[S]. SAE, 2003. http://www.sae.org/standards/content/arp5905/
    [2]
    Federal Aviation Administration. FAR Part25 Airworthiness standards: Transport category airplanes[S]. Federal Aviation Agency, 2008.
    [3]
    中国民用航空局. CCAR-25-R4中国民用航空规章第25部: 运输类飞机适航标准[S]. 北京: 中国民用航空局, 2011.
    [4]
    SAE Aerospace. SAE AIR4906 Droplet sizing instrumentation used in icing facilities[S]. SAE, 1995. https://www.sae.org/standards/content/air4906/
    [5]
    SAE. SAE AIR5320 Summary of icing simulation test facilities[S]. SAE, 1999. https://www.sae.org/standards/content/air5320/
    [6]
    SAE Aerospace. SAE AIR5624 Aircraft inflight icing terminology[S]. SAE, 2008. http://articles.sae.org/2917/
    [7]
    Sten L E, Ide R F. NASA glenn icing research tunnel: 2014 and 2015 cloud calibration procedures and results[R]. NASA/TM-2015-218758, 2015. https://www.sciencedirect.com/science/article/pii/S0376042118300058
    [8]
    Van Zante J F, Ide R F. NASA glenn icing research tunnel: 2014 cloud calibration procedure and results[R]. NASA/TM-2014-218392, 2014. DOI: 10.2514/6.2012-2933
    [9]
    Bellucci M, Esposito B M. Calibration of the CIRA IWT in the low speed configuration[R]. AIAA-2007-1092, 2007. http://edu.wanfangdata.com.cn/Periodical/Detail/kjdb201325007
    [10]
    Ragni A, Esposito B. Calibration of the CIRA IWT in the high speed configuration[R]. AIAA-2005-471, 2005. http://www.academia.edu/28736885/Calibration_of_the_CIRA_IWT_in_the_High_Speed_Configuration
    [11]
    林贵平, 卜雪琴, 申晓斌, 等.飞机结冰与防冰技术[M].北京:北京航空航天大学出版社, 2016.
    [12]
    朱春玲, 朱程香.飞机结冰及其防护[M].北京:科学出版社, 2016.
    [13]
    程尧, 张平涛, 郭向东, 等.机载式相位多普勒干涉仪在结冰风洞的应用[J].兵工自动化, 2017, 36(9):55-57. http://www.cqvip.com/QK/90272A/201502/664576270.html

    Cheng Y, Zhang P T, Guo X D, et al. Application of PDI-FPDR in icing wind tunnel[J]. Ordnance Industry Automation, 2017, 36(9):55-57. http://www.cqvip.com/QK/90272A/201502/664576270.html
    [14]
    赖庆仁, 郭龙, 李明, 等.结冰风洞液态水含量测量装置设计与实现[J].空气动力学学报. 2016, 24(6):750-755. http://industry.wanfangdata.com.cn/dl/Detail/Periodical?id=Periodical_kjdb200921018

    Lai Q R, Guo L, Li M, et al. Design and implementation of the device for liquid water content measurement in icing wind tunnel[J]. Acta Aerodynamica Sinica, 2016, 24(6):750-755. http://industry.wanfangdata.com.cn/dl/Detail/Periodical?id=Periodical_kjdb200921018
    • Related Articles

  • Related Articles

    [1]HE Chao, SUN Peng, LIN Jingzhou, XU Xiaobin, CHEN Lei. Design and application of the dynamic stage separation device in hypersonic wind tunnel[J]. Journal of Experiments in Fluid Mechanics, 2022, 36(5): 90-95. DOI: 10.11729/syltlx20200119
    [2]Wang Xiaopeng, Zhang Chen'an, Liu Chunfeng, Wang Famin, Ye Zhengyin. Support interference and correction of cold-flow force test for air-breathing hypersonic vehicle in wind tunnel[J]. Journal of Experiments in Fluid Mechanics, 2018, 32(6): 27-33. DOI: 10.11729/syltlx20180116
    [3]Ding Feng, Liu Jun, Shen Chibing, Liu Zhen, Chen Shaohua, Huang Wei. An overview of waverider design concept in airframe-inlet integration methodology for air-breathing hypersonic vehicles[J]. Journal of Experiments in Fluid Mechanics, 2018, 32(6): 16-26. DOI: 10.11729/syltlx20180080
    [4]Xu Xiaobin, Shu Haifeng, Xie Fei, Wang Xiong, Guo Leitao. Research progress on aerodynamic test technology of hypersonic wind tunnel for air-breathing aerocraft[J]. Journal of Experiments in Fluid Mechanics, 2018, 32(5): 29-40. DOI: 10.11729/syltlx20180053
    [5]Deng Fan, Ye Youda, Jiao Zihan, Liu Hui. Research on HIFiRE project's hypersonic vehicle integrated design of aerodynamic and scramjet propulsion[J]. Journal of Experiments in Fluid Mechanics, 2017, 31(2): 73-80. DOI: 10.11729/syltlx20160125
    [6]JIANG Wei, YANG Yun-jun, CHEN He-wu. Investigations on aerodynamics of the spike-tipped hypersonic vehicles[J]. Journal of Experiments in Fluid Mechanics, 2011, 25(6): 28-32,53. DOI: 10.3969/j.issn.1672-9897.2011.06.006
    [7]HE Kai-feng, WANG Qing, QIAN Wei-qi, HE Zheng-chun. Review of aerodynamic and aero-thermodynamic parameter estimation research for hypersonic aircraft[J]. Journal of Experiments in Fluid Mechanics, 2011, 25(5): 99-104. DOI: 10.3969/j.issn.1672-9897.2011.05.020
    [8]KHARITONOV A M, ZVEGINTSEV V I, CHIRKASHENKO V F, BRODETSKY M D, MAZHUL I I, VASENEV L G, MUYLAERT J M, KORDULLA W, PAULAT J C. Aerodynamic investigation of aerospace vehicles in the new hypersonic wind tunnel AT-303 at ITAM[J]. Journal of Experiments in Fluid Mechanics, 2006, 20(4): 10-19. DOI: 10.3969/j.issn.1672-9897.2006.04.002
    [9]Heat flux measurement test of the hypersonic vehicle[J]. Journal of Experiments in Fluid Mechanics, 2004, 18(1): 29-32,37. DOI: 10.3969/j.issn.1672-9897.2004.01.007
    [10]The calculations of aerodynamic heating and viscous friction forces on the surface of hypersonic flight vehicle[J]. Journal of Experiments in Fluid Mechanics, 2002, 16(1): 8-20. DOI: 10.3969/j.issn.1672-9897.2002.01.002

  • Cited by

    Periodical cited type(3)

    1. 管新蕾，孙小姣，王维，王利军. 弧形涡流发生器对湍流相干结构及强化换热的影响. 实验流体力学. 2024(04): 104-112 . 本站查看
    2. 朱寅鑫，彭文强，罗振兵，康赢，赵志杰，程盼，刘杰夫. 全叶高合成双射流对大折转角扩压叶栅的影响. 航空学报. 2023(12): 84-95 .
    3. 蔡明，高丽敏，刘哲，黎浩学，陈顺. 亚声速压气机平面叶栅及其改型的吹风试验. 实验流体力学. 2021(02): 36-42 . 本站查看

    Other cited types(0)

Catalog

    Get Citation
    PDF
    XML

    Article Metrics

    Article views (366) PDF downloads (31) Cited by(3)
    Related

    Submit Article

    Submission Guidelines

    Contact Us

    Qrcode

    Copyright © Editorial Department of Experimental Fluid Mechanics All Rights Reserved京ICP备14006930号-5

    Address: P. O. Box 11-9, 6 South Section of Second Ring Road, Mianyang, Sichuan 621000, China

    Tel: 0816-2463376 Email: syltlx@163.com

    Supported by: Beijing Renhe Information Technology Co., Ltd.  Baidu Analytics

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return
    x Close Forever Close