留言板

尊敬的读者、作者、审稿人, 关于本刊的投稿、审稿、编辑和出版的任何问题, 您可以本页添加留言。我们将尽快给您答复。谢谢您的支持!

姓名
邮箱
手机号码
标题
留言内容
验证码

双发进气道低速风洞试验方法研究

唐建平 尚银辉 李东 巫朝君 徐彬彬 金玲

唐建平,尚银辉,李东,等. 双发进气道低速风洞试验方法研究[J]. 实验流体力学,doi: 10.11729/syltlx20220059
引用本文: 唐建平,尚银辉,李东,等. 双发进气道低速风洞试验方法研究[J]. 实验流体力学,doi: 10.11729/syltlx20220059
TANG J P,SHANG Y H,LI D,et al. Research on the double-inlet test method in low speed wind tunnel[J]. Journal of Experiments in Fluid Mechanics, doi: 10.11729/syltlx20220059
Citation: TANG J P,SHANG Y H,LI D,et al. Research on the double-inlet test method in low speed wind tunnel[J]. Journal of Experiments in Fluid Mechanics, doi: 10.11729/syltlx20220059

双发进气道低速风洞试验方法研究

doi: 10.11729/syltlx20220059
详细信息
    作者简介:

    唐建平:(1976—),男,湖南茶陵人,高级工程师。研究方向:进气道试验技术。通信地址:四川省绵阳市涪城区中国空气动力研究与发展中心(621000)。E-mail:tjpatgfkd@163.com

    通讯作者:

    E-mail:tjpatgfkd@163.com

  • 中图分类号: V211.73

Research on the double-inlet test method in low speed wind tunnel

  • 摘要: 为在4 m量级低速风洞中开展双发进气道试验,在中国空气动力研究与发展中心低速空气动力研究所4 m × 3 m风洞中建立了一种双发进气道试验方法:模型采用单支杆方式支撑,以两路独立的引射器和数字式调压阀系统实现双发进气道的流量模拟与控制。模型迎角范围−10°~90°,侧滑角范围−45°~45°,最大模拟流量分别为2.9 kg/s和1.4 kg/s。采用该方法完成了一期双发进气道低速试验,试验结果表明:模型受管路气动影响小;独立的模型和引射器支撑机构适应各种模型支撑要求;双发流量模拟和控制完全独立,满足开展双发进气道相互影响试验的需求。
  • 图  1  双发进气道低速试验总体方案

    Figure  1.  Scheme of double-inlet low speed test system

    图  2  双引射器洞内安装图

    Figure  2.  Double ejector installed in the test section

    图  3  流量控制数字阀

    Figure  3.  Digital valves for mass flow controlling

    图  4  双流量计洞内安装图

    Figure  4.  Double-flowmeter installed in the wind tunnel

    图  5  测量段测点布置示意图

    Figure  5.  Distribution of measuring section points

    图  6  双发进气道试验模型

    Figure  6.  A double-inlet test model

    图  7  双发进气道风洞试验图

    Figure  7.  The double-inlet test in wind tunnel

    图  8  双发进气道出口总压云图(逆航向)

    Figure  8.  Total pressure distribution of the double-inlet exits

    图  9  左进气道固定流量下的右进气道特性曲线

    Figure  9.  The characteristic curves of right inlet with different mass flows of the left inlet

    图  10  Ma=0时双发进气道出口总压云图比较(逆航向)

    Figure  10.  Total pressure distribution of the double-inlet exits

    表  1  进气道σ匹配特性

    Table  1.   Inlet characteristics of matching σ parameter

    Ma左进气道匹配σ右进气道匹配σ
    试验值计算值差量试验值计算值差量
    0 0.926 0.918 0.9% 0.927 0.918 1.0%
    0.1 0.946 0.940 0.6% 0.946 0.940 0.6%
    0.2 0.960 0.956 0.4% 0.961 0.956 0.5%
    下载: 导出CSV
  • [1] 中国人民解放军总装备部军事训练教材编辑工作委员会. 低速风洞试验[M]. 北京: 国防工业出版社, 2002.
    [2] SMITH A R, THORNE R, GOUTTENOIRE C, et al. Aerodynamic aspects of application of negative scarf intakes to high bypass ratio civil turbofans[C]//Proc of the 41st AIAA/ASME/SAE/ASEE Joint Propulsion Conference & Exhibit. 2005: 4205. doi: 10.2514/6.2005-4205
    [3] AREND D J, CASTNER R S, FRATE F C. A low cost, compact and versatile rig for integrated inlet and propulsion systems research[C]//Proc of the 44th AIAA Aerospace Sciences Meeting and Exhibit, Reno, Nevada. Reston, Virginia: AIAA, 2006: 1313. doi: 10.2514/6.2006-1313
    [4] CASTNER R S, SIMERLY S, RANKIN M. Supersonic inlet test for a quiet supersonic transport technology demonstrator in the NASA Glenn 8-foot by 6-foot supersonic wind tunnel[C]//Proc of the 2018 Applied Aerodynamics Conference. 2018: 2850. doi: 10.2514/6.2018-2850
    [5] WOLTER J D. Multipurpose rotating rake arrays for integrated inlet and fan stage performance measurement[R]. National Aeronautics and Space Administration, GRC-E-DAA-TN47296, 2018.
    [6] GUIMARÃES T, LOWE K T, O’BRIEN W F. Vortical flow development in round ducts across scales for engine inlet applications[J]. Experiments in Fluids, 2019, 60(4): 1–16. doi: 10.1007/s00348-019-2702-9[LinkOut
    [7] 高静, 郝卫东, 闫永昌, 等. 进气道低速特性试验技术研究[J]. 流体力学实验与测量, 2004, 18(1): 38–42. doi: 10.3969/j.issn.1672-9897.2004.01.009

    GAO J, HAO W D, YAN Y C, et al. Experimental investigation on low speed characteristics of inlet[J]. Experiments and Measurements in Fluid Mechanics, 2004, 18(1): 38–42. doi: 10.3969/j.issn.1672-9897.2004.01.009
    [8] 杨应凯. Bump进气道设计与试验研究[J]. 空气动力学学报, 2007, 25(3): 336–338,350. doi: 10.3969/j.issn.0258-1825.2007.03.010

    YANG Y K. The research of bump inlet design and test[J]. Acta Aerodynamica Sinica, 2007, 25(3): 336–338,350. doi: 10.3969/j.issn.0258-1825.2007.03.010
    [9] 巫朝君, 孔鹏, 王勋年, 等. 基于张线尾撑的进气道低速风洞试验技术研究[J]. 实验流体力学, 2012, 26(2): 86–89. doi: 10.3969/j.issn.1672-9897.2012.02.019

    WU C J, KONG P, WANG X N, et al. The investigation of the inlet test technology based on wire sting support in low speed wind tunnel[J]. Journal of Experiments in Fluid Mechanics, 2012, 26(2): 86–89. doi: 10.3969/j.issn.1672-9897.2012.02.019
    [10] 陈洪, 刘李涛, 巫朝君. 8 m × 6 m风洞大尺度模型进气道和喷流试验技术[J]. 空气动力学学报, 2017, 35(6): 875–878. doi: 10.7638/kqdlxxb-2015.0133

    CHEN H, LIU L T, WU C J. Inlet and jet test techniques for large scale model in 8 m × 6 m Low Speed Wind Tunnel[J]. Acta Aerodynamica Sinica, 2017, 35(6): 875–878. doi: 10.7638/kqdlxxb-2015.0133
    [11] 唐滨滨, 李长坤. 一种低速风洞大流量进气道试验系统研制[J]. 推进技术, 2018, 39(12): 2839–2844. doi: 10.13675/j.cnki.tjjs.2018.12.024

    TANG B B, LI C K. Development of a large mass flow inlet test system in low speed wind tunnel[J]. Journal of Propulsion Technology, 2018, 39(12): 2839–2844. doi: 10.13675/j.cnki.tjjs.2018.12.024
    [12] 巫朝君, 徐彬彬, 张为卓, 等. 低速风洞进气道试验柱形分布式引射器优化设计[J]. 航空动力学报, 2020, 35(12): 2482–2488. doi: 10.13224/j.cnki.jasp.2020.12.002

    WU C J, XU B B, ZHANG W Z, et al. Design and optimization of columniform distributed ejector for low speed wind tunnel inlet test[J]. Journal of Aerospace Power, 2020, 35(12): 2482–2488. doi: 10.13224/j.cnki.jasp.2020.12.002
    [13] KOJIMA T, TANATSUGU N, SATO T, et al. Development study on axisymmetric air inlet for ATREX engine[C]//Proc of the 10th AIAA/NAL-NASDA-ISAS International Space Planes and Hypersonic Systems and Technologies Conference. 2001: 1895. doi: 10.2514/6.2001-1895
    [14] ALBERTSON C, EMAMI S, TREXLER C. Mach 4 test results of a dual-flowpath, turbine based combined cycle inlet[C]//Proc of the 14th AIAA/AHI Space Planes and Hypersonic Systems and Technologies Conference. 2006: 8138. doi: 10.2514/6.2006-8138
    [15] CARTER M B, SHEA P R, FLAMM J D, et al. Experimental evaluation of inlet distortion on an ejector powered hybrid wing body at take-off and landing conditions (invited)[C]//Proc of the 54th AIAA Aerospace Sciences Meeting. 2016: 0010. doi: 10.2514/6.2016-0010
    [16] 欧平, 陈强, 田晓虎, 等. 双发进气道抽吸试验系统及流量高精度测量技术[J]. 空气动力学学报, 2016, 34(3): 392–397. doi: 10.7638/kqdlxxb-2015.0118

    OU P, CHEN Q, TIAN X H, et al. The pumping system and precise mass flow measuring technique for double-inlet wind tunnel test[J]. Acta Aerodynamica Sinica, 2016, 34(3): 392–397. doi: 10.7638/kqdlxxb-2015.0118
  • 加载中
图(10) / 表(1)
计量
  • 文章访问数:  233
  • HTML全文浏览量:  101
  • PDF下载量:  25
  • 被引次数: 0
出版历程
  • 收稿日期:  2022-06-30
  • 修回日期:  2022-09-30
  • 录用日期:  2022-10-13
  • 网络出版日期:  2022-12-01

目录

    /

    返回文章
    返回

    重要公告

    www.syltlx.com是《实验流体力学》期刊唯一官方网站,其他皆为仿冒。请注意识别。

    《实验流体力学》期刊不收取任何费用。如有组织或个人以我刊名义向作者、读者收取费用,皆为假冒。

    相关真实信息均印刷于《实验流体力学》纸刊。如有任何疑问,请先行致电编辑部咨询并确认,以避免损失。编辑部电话0816-2463376,2463374,2463373。

    请广大读者、作者相互转告,广为宣传!

    感谢大家对《实验流体力学》的支持与厚爱,欢迎继续关注我刊!


    《实验流体力学》编辑部

    2021年8月13日