Effect of bleed on efficiency evaluation of high pressure compressor

CHEN Yunyong; MA Changyou; SUN Zhenyu; CHEN Zhilong

doi:10.11729/syltlx20200097

Volume 35 Issue 2

Apr. 2021

Turn off MathJax

Article Contents

Article Navigation > Journal of Experiments in Fluid Mechanics > 2021 > 35(2): 43-49

CHEN Yunyong, MA Changyou, SUN Zhenyu, et al. Effect of bleed on efficiency evaluation of high pressure compressor[J]. Journal of Experiments in Fluid Mechanics, 2021, 35(2): 43-49. doi: 10.11729/syltlx20200097

Citation:

PDF( 5560 KB)

Effect of bleed on efficiency evaluation of high pressure compressor

doi: 10.11729/syltlx20200097

AECC Shanghai Commercial Aircraft Engine Manufacturing Co., Ltd., Shanghai 201306, China

Received Date: 2020-08-02
Rev Recd Date: 2020-09-15
Publish Date: 2021-04-01

Abstract

Abstract

On the basis of summarizing the differences and correlations between temperature rise efficiency and torque efficiency, two kinds of isentropic efficiency evaluation methods for the high pressure compressor with inter stage bleed are studied in this paper. The influence of inter stage bleed parameters on the two isentropic efficiency corrections is discussed, and the experimental verification is carried out. The results show that: the torque efficiency is always lower than the temperature rise efficiency due to the mechanical transmission loss of the compressor; the temperature rise efficiency of the compressor before and after the correction of the inter stage bleed parameters has no significant difference, and the variation range is within ±0.5%; considering the correction of inter stage bleed parameters, the torque efficiency of the compressor can be significantly reduced, but the relative decrease is not more than the total bleed rate, and the reduction degree is related to the bleed rate and the stage position where the bleed is located; when the inter stage bleed with a large flow rate is conducted at the inlet side of the compressor, the torque efficiency should be corrected, otherwise the torque efficiency may be greater than the temperature rise efficiency.
- axial flow compressor,
- isentropic efficiency,
- torque efficiency,
- inter-stage bleeding,
- temperature rise efficiency

FullText(HTML)

References(15)

References

[1]	LEI V M, SPAKOVSZKY Z S, GREITZER E M. A criterion for axial compressor hub-corner stall[J]. Journal of Turboma-chinery, 2008, 130(3): 031006. doi: 10.1115/1.2775492
[2]	TAYLOR J V, MILLER R J. Competing three-dimensional mechanisms in compressor flows[J]. Journal of Turboma-chinery, 2017, 139(2): 021009. doi: 10.1115/1.4034685
[3]	GBADEBO S A, CUMPSTY N A, HYNES T P. Control of three-dimensional separations in axial compressors by tailored boundary layer suction[J]. Journal of Turbomachinery, 2008, 130(1): 011004. doi: 10.1115/1.2749294
[4]	NERGER D, SAATHOFF H, RADESPIEL R, et al. Experimental investigation of endwall and suction side blowing in a highly loaded compressor stator cascade[J]. Journal of Turbomachinery, 2012, 134(2): 021010. doi: 10.1115/1.4003254
[5]	强艳, 陈云永, 李游, 等. 压气机效率计算方法的探讨[J]. 燃气涡轮试验与研究, 2019, 32(6): 26-30. https://www.cnki.com.cn/Article/CJFDTOTAL-RQWL201906006.htm QIANG Y, CHEN Y Y, LI Y, et al. Calculation methodology of compressor efficiency[J]. Gas Turbine Experiment and Research, 2019, 32(6): 26-30. https://www.cnki.com.cn/Article/CJFDTOTAL-RQWL201906006.htm
[6]	GRIFFIN R G, SMITH L H Jr. Experimental evaluation of outer case blowing or bleeding of a single stage axial flow compressor. Part Ⅰ: Design of rotor blowing and bleeding configurations[R]. NASA CR-54587, 1966.
[7]	KOCH C C. Experimental evaluation of outer case blowing or bleeding of a single stage axial flow compressor. Part VI: Final report[R]. NASA CR-54592, 1970.
[8]	晏松, 楚武利. 叶顶引气位置对自循环机匣处理扩稳能力的研究[J]. 推进技术, 2019, 40(12): 2731-2738. doi: 10.13675/j.cnki.tjjs.180704 YAN S, CHU W L. Study on enhanced stability ability of self-circulating casing treatment by blade tip bleed positions[J]. Journal of Propulsion Technology, 2019, 40(12): 2731-2738. doi: 10.13675/j.cnki.tjjs.180704
[9]	姚丁夫, 成金鑫, 陈江, 等. 引气对多级轴流压气机性能影响的数值研究[J]. 航空动力学报, 2016, 31(5): 1186-1195. doi: 10.13224/j.cnki.jasp.2016.05.021 YAO D F, CHENG J X, CHEN J, et al. Numerical investigation of bleeding effect on performance of multistage axial compressor[J]. Journal of Aerospace Power, 2016, 31(5): 1186-1195. doi: 10.13224/j.cnki.jasp.2016.05.021
[10]	VÁZQUEZ R, SÁNCHEZ J M. Temperature measurement system for low pressure ratio turbine testing[C]//Proceedings of ASME Turbo Expo 2003, Collocated With the 2003 International Joint Power Generation Conference. 2009. doi: 10.1115/GT2003-38685
[11]	任铭林, 向宏辉. 有关轴流压气机效率问题的探讨[J]. 燃气涡轮试验与研究, 2009, 22(4): 9-14. doi: 10.3969/j.issn.1672-2620.2009.04.002 REN M L, XIANG H H. Exploration of efficiency in axial compressor[J]. Gas Turbine Experiment and Research, 2009, 22(4): 9-14. doi: 10.3969/j.issn.1672-2620.2009.04.002
[12]	向宏辉, 王掩刚, 高杰, 等. 轴流压气机效率测量两类影响因素的试验研究[J]. 燃气涡轮试验与研究, 2019, 32(3): 1-7. doi: 10.3969/j.issn.1672-2620.2019.03.001 XIANG H H, WANG Y G, GAO J, et al. Experimental investigation of two effect factors on axial flow compressor efficiency measurement[J]. Gas Turbine Experiment and Research, 2019, 32(3): 1-7. doi: 10.3969/j.issn.1672-2620.2019.03.001
[13]	马昌友, 侯敏杰, 幸晓龙. 基于静叶特性的匹配环境下CDFS性能测量方法[J]. 燃气涡轮试验与研究, 2018, 31(1): 1-6. https://www.cnki.com.cn/Article/CJFDTOTAL-RQWL201801002.htm MA C Y, HOU M J, XING X L. Measurement research on performance of core driven fan stage in the matching environment based on stator characteristics[J]. Gas Turbine Experiment and Research, 2018, 31(1): 1-6. https://www.cnki.com.cn/Article/CJFDTOTAL-RQWL201801002.htm
[14]	马昌友, 侯敏杰, 梁俊, 等. 高负荷压气机首级可调静叶进口气流参数测试误差分析[J]. 燃气涡轮试验与研究, 2020, 33(2): 7-13. https://www.cnki.com.cn/Article/CJFDTOTAL-RQWL202002003.htm MA C Y, HOU M J, LIANG J, et al. Inlet airflow measuring error analysis of the first stage adjustable stator of a high load compressor[J]. Gas Turbine Experiment and Research, 2020, 33(2): 7-13. https://www.cnki.com.cn/Article/CJFDTOTAL-RQWL202002003.htm
[15]	赵斌, 李绍斌, 周盛. 引气对跨声轴流压气机性能的影响[J]. 北京航空航天大学学报, 2011, 37(1): 15-20. doi: 10.13700/j.bh.1001-5965.2011.01.005 ZHAO B, LI S B, ZHOU S. Bleeding impact on performance of transonic axial compressor[J]. Journal of Beijing University of Aeronautics and Astronautics, 2011, 37(1): 15-20. doi: 10.13700/j.bh.1001-5965.2011.01.005