Structural design of a small cryogenic wind tunnel compressor rotor

Chen Zhenhua; Nie Xuqing; Yang Wenguo

doi:10.11729/syltlx20170094

Volume 32 Issue 1

Turn off MathJax

Article Contents

Article Navigation > Journal of Experiments in Fluid Mechanics > 2018 > 32(1): 98-104

Chen Zhenhua, Nie Xuqing, Yang Wenguo. Structural design of a small cryogenic wind tunnel compressor rotor[J]. Journal of Experiments in Fluid Mechanics, 2018, 32(1): 98-104. doi: 10.11729/syltlx20170094

Citation:

PDF( 5980 KB)

Structural design of a small cryogenic wind tunnel compressor rotor

doi: 10.11729/syltlx20170094

Facility Design and Instrumentation Institute, China Aerodynamics Research and Development Center, Mianyang Sichuan 621000, China

Received Date: 2017-07-31
Rev Recd Date: 2017-10-10
Publish Date: 2018-02-25

Abstract

Abstract

The axial compressor is the power equipment of the cryogenic wind tunnel. It has the characteristics of the wide temperature range and high speed of operation. The compressor rotor structural design was studied in this paper. Key technologies of the compressor design were discussed in detail, including shaft-hub connection, hub-blade connection, bearing selection, lubrication method, seal structure, heat protection scheme, et al. The compressor rotor dynamical characteristics under elastic supporting was calculated using the FEM method. The thermal-structure coupling simulation of the rotor was conducted. Calculation results show that the rotor critical speed is much higher than the maximum speed, the maximum stress value of the thrust bearing housing is about 170MPa when the temperature dropping stage ends, and the safety factor is bigger than 1.5. United debugging of the compressor on a small cryogenic wind tunnel was carried out. Experimental results show that when the total temperature of the wind tunnel drops to 110K, the bearing temperature is higher than 5℃, and the bearing vibration value is lower than 3mm/s. They both meet the design requirement, which verifies that this compressor rotor design is reliable.
- cryogenic compressor,
- rotor structural,
- rotor dynamics,
- dynamic seal,
- thermal-structure analysis

FullText(HTML)

References(19)

References

[1]	廖达雄, 黄知龙, 陈振华, 等.大型低温高雷诺数风洞及其关键技术综述[J].实验流体力学, 2014, 28(2):1-6, 20. doi: 10.11729/syltlx20130102 Liao D X, Huang Z L, Chen Z H, et al. Review on large-scale cryogenic wind tunnel and key technologies[J]. Journal of Experimentsin Fluid Mechanics, 2014, 28(2):1-6, 20. doi: 10.11729/syltlx20130102
[2]	Zhang Z, Niu L. Current status and key technologies of cryogenic wind tunnel[J]. Cryogenics, 2015, 2:57-62. http://en.cnki.com.cn/Article_en/CJFDTotal-DWGC201502011.htm
[3]	Green J, Quest G. A short history of the European Transonic Wind Tunnel (ETW)[J]. Aerospace Sciences, 2011, 47:319-368. doi: 10.1016/j.paerosci.2011.06.002
[4]	Trevor B, Managing D. The European Transonic Wind Tunnel-testing at flight Reynolds numbers[R]. AIAA-96-0227, 1996.
[5]	惠增宏, 何明一. NF-6风洞压缩机及驱动系统研制[J].实验流体力学, 2005, 19(4):31-35. http://manu27.magtech.com.cn/Jweb_jefm/CN/abstract/abstract9436.shtml Hui Z H, He M Y. NF-6 wind tunnel compressor and driving system[J]. Journal of Experiments in Fluid Mechanics, 2005, 19(4):31-35. http://manu27.magtech.com.cn/Jweb_jefm/CN/abstract/abstract9436.shtml
[6]	周恩民, 程松, 许靖, 等. 0.6m连续式跨声速风洞AV90-3轴流压缩机喘振边界测试研究[J].实验流体力学, 2014, 28(5):81-85. http://www.docin.com/p-1164306963.html Zhou E M, Cheng S, Xu J, et al. Surge margin test and research of AV90-3 axial compressor in 0.6m continuous transonic wind tunnel[J]. Journal of Experiments in Fluid Mechanics, 2014, 28(5):81-85. http://www.docin.com/p-1164306963.html
[7]	熊波, 周恩民, 程松, 等. 0.6m连续式风洞调试运行关键技术研究[J].实验流体力学, 2016, 30(4):81-86. http://mall.cnki.net/magazine/Article/LTLC201604004.htm Xiong B, Zhou E M, Cheng S, et al. Research on key technologies of debugging and operating in 0.6m×0.6m continuous transonic wind tunnel[J]. Journal of Experiments in Fluid Mechanics, 2016, 30(4):81-86. http://mall.cnki.net/magazine/Article/LTLC201604004.htm
[8]	姜妍, 印明洋, 王广兰, 等.百万吨乙烯压缩机组中低温压缩机结构设计中关键技术[J].通用机械, 2009, (5):18-21. http://kns.cnki.net/KCMS/detail/detail.aspx?filename=tyjs200905007&dbname=CJFD&dbcode=CJFQ Jiang Y, Yin M Y, Wang G L, et al. Key technologies in structural design of a million-ton ethylene cryogenic compressor unit[J]. General Machinery, 2009, (5):18-21. http://kns.cnki.net/KCMS/detail/detail.aspx?filename=tyjs200905007&dbname=CJFD&dbcode=CJFQ
[9]	Singh M, Lucas G. Blade design and analysis for steam turbines[M]. New York:Mc Graw Hill, 2011.
[10]	石炜, 温卫东, 崔海涛.榫连接结构微动疲劳寿命研究[J].航空动力学报, 2014, 29(1):104-110. http://industry.wanfangdata.com.cn/hk/Detail/Thesis?id=Thesis_D565202 Shi W, Wen W D, Cui H T. Research on fretting fatigue life of dovetail joints[J]. Journal of Aerospace Power, 2014, 29(1):104-110. http://industry.wanfangdata.com.cn/hk/Detail/Thesis?id=Thesis_D565202
[11]	成玫. 转子-轴承-密封系统动力学特性研究[D]. 上海: 上海交通大学, 2009. Cheng M. Study on dynamics of a rotor-bearing-seal system[D]. Shanghai: Shanghai Jiao Tong University, 2009.
[12]	王维民, 齐鹏逸, 李启行, 等.离心式压缩机转子系统稳定性控制方法研究[J].振动与冲击, 2014, 33(6):102-106. https://www.cnki.com.cn/qikan-FENG201302005.html Wang W M, Qi P Y, Li Q H, et al. Instability control strategy for rotor-bearing system in centrifugal compressor[J]. Journal of Vibration and Shock, 2014, 33(6):102-106. https://www.cnki.com.cn/qikan-FENG201302005.html
[13]	Ishida Y, Yamamoto T. Linear and nonlinear rotordynamics[M]. Weinheim:Wiley, 2012.
[14]	黄钟岳.透平式压缩机[M].北京:化学工业出版社, 2014.
[15]	马文生, 陈照波, 焦映厚, 等.迷宫密封结构对泄漏量和轴系临界转速影响分析研究[J].振动工程学报, 2013, 26(6):823-830. http://www.wenkuxiazai.com/doc/b9e85c77453610661fd9f421.html Ma W S, Chen Z B, Jiao Y H, et al. Leakage and critical speed effect of labyrinth seal structure[J]. Journal of Vibration Engineering, 2013, 26(6):823-830. http://www.wenkuxiazai.com/doc/b9e85c77453610661fd9f421.html
[16]	杨东辉, 王雷雷, 沈宇红, 等.低温闪蒸气压缩机气缸温度场的有限元分析[J].西安交通大学学报, 2013, 47(1):48-51, 67. http://mall.cnki.net/magazine/Article/YSJJ201605008.htm Yang D H, Wang L L, Shen Y H, et al. Finite analysis of cylinder temperature field in boil-off gas compressor[J]. Journal of Xi'an Jiao Tong University, 2013, 47(1):48-51, 67. http://mall.cnki.net/magazine/Article/YSJJ201605008.htm
[17]	张超, 徐自力, 刘石, 等.采用热固双向耦合模型的转子热应力计算方法研究[J].西安交通大学学报, 2014, 48(4):68-72. doi: 10.7652/xjtuxb201404012 Zhang C, Xu Z L, Liu S, et al. Steam turbine rotor thermal stress calculation with thermo-structural coupled model[J]. Journal of Xi'an Jiao Tong University, 2014, 48(4):68-72. doi: 10.7652/xjtuxb201404012
[18]	崔立, 王黎钦, 郑德志, 等.航空发动机高速滚子轴承动态特性分析[J].航空学报, 2008, 29(2):492-498. http://www.cqvip.com/QK/91925X/200802/26752141.html Cui L, Wang L Q, Zheng D Z, et al. Analysis on dynamic characteristics of aero-engine high-speed roller bearings[J]. Acta Aeronautica et Astronautica Sinica, 2008, 29(2):492-498. http://www.cqvip.com/QK/91925X/200802/26752141.html
[19]	王正.转动机械的转子动力学设计[M].北京:清华大学出版社, 2015.